KNX Master (Slave) Curtain Control Motor is a curtain controller controlled by a panel or other device, and includes host and slave. The Master (Slave) Curtain Control Motor supports manual mode, and overheat protection.
KNX Master (Slave) Curtain Control Motor is a curtain controller controlled by a panel or other device, and includes host and slave. The Master (Slave) Curtain Control Motor supports manual mode, and overheat protection.
■ Standard control (with percentage)
■ Simple control (without percentage)
■ Automatic distance measurement
■ Manual mode: Long drag, short drag.
■ Control to open, close, stop and percentage open/close.
■ Position and status response (open, close, stop, percentage, limited position, etc.)
■ Status recovery upon power on.
■ Safety control: Control the curtain position according to wind, rain, frost signal
■ Auto control: Control the curtain position according to sun status, heating, cooling signal
■ Scene control
■ Forced position operation
■ Trigger control
■ Status save when power off
Basic Parameters
Model M/WM70M.1 (Master) M/WM70S.1 (Slave)
Working voltage 21-30V DC (Master) 12V DC (Slave, from Master) Working current 10mA/30V DC (Master)
Input voltage 220V AC 50Hz
Communication KNX (Master)
Slave interface 6P network port
Rated power 70W
Rated torque 1.0N.m
Rated speed 112rpm
Rail belt speed 16cm/s
External Environment
Working temperature -5℃~45℃
Working relative humidity ≤90%
Storage temperature -20℃~60℃
Storage relative humidity ≤93%
Specifications
Dimensions 284×70×50(mm)
Net weight
1554g(master) 1543g(slave) Housing material ABS, aluminum
Installation Wall mounting
Insulation rating E
Protection rating (Compliant with EN 60529) IP41